Briggs & Stratton 5 HP, Руководство по устранению неполадок и ремонту

Страница: 34 / 76

32
8. Remove two stainless steel screws
(Figure 55)
and
stud from the input shaft carrier
.
Remove the
input shaft carrier assembly from the gear case.
Inspect shaft bushings inside the gear case. Inspect the seal
and the support for the gear selector shaft .
Inspect the seal for the drive shaft. Inspect all lower unit
parts for visual evidence of wear or damage. Replace o-rings
. Replace any worn or damaged parts.
Sliding Clutch
1. Install the propeller shaft to Briggs & Stratton Tool
(#19555) , Insert the tool knob
(Figure 56)
through the tool body and into the shaft to secure the
shaft to the tool.
2. Insert the pin through the tool into the knob to
secure the knob to the tool.
3. With the shaft properly installed to the tool, remove
and discard the roll pin
(Figure 56)
from the
sliding clutch. Disassemble the tool and the propeller
shaft/sliding clutch assembly.
Replace the shaft if it is bent or if the clutch splines are
worn. Replace the roll pin. Inspect the sliding clutch and
spring. Replace worn or damaged components.
4. Install the shaft, spring and sliding clutch to the tool.
Assemble the shaft in reverse order.
3
1
2
20
21 19 18
17 16
15
Section 3 • Disassembly
5 HP Outboard • Troubleshooting & Repair Manual
3
Figure 56 — Tool
(#19555)
Figure 55 — Shifting Components
20
1
2
3
21
19
18
16
15
17
WARNING
The spring is under pressure. Use
caution when removing or
installing the tool handle and the
spring. Always wear eye
protection.
CAUTION
: Replace the roll pin whenever
it has been removed from the propeller
shaft. Damage to gear case components
could result from a missing or mis-installed
roll pin.