BQS AB730, Инструкция по эксплуатации

Страница: 13 / 27

Tightening the harness
1. Pull the harness straps up to remove the slack from the lap
section of the harness, then pull the harness regulating strap until
the harness is fully stretched (5.11).
2. The harness should be as tight as possible without causing
discomfort to your child.
3. Make sure the lap section of the harness is positioned as low
as possible, surrounding your child’s hips and not his stomach.
4.
A harness that is not properly tightened can be dangerous.
Check the harness adjustment and tighten whenever you put
your child in the child safety seat.
Loosening the harness
1.
The harness is loosened by pressing the adjustment button of
the K harness (under the seat cover) at the front of the seat.
2. Press the lever that is marked with “ press ” down with one hand
while holding both harness straps with your other hand; pull the
harness straps towards you to loosen the harness (5.12).
3. Be careful when adjusting the harness strap not to trap the
harness adjustment strap when you press the button down.
6. CLEANING AND MAINTENANCE
Removing the buckle protector and the lower harness
1.
Locate the harness metal connector R at the back of the seat
(6.1).
2.
Unhook both harness straps to release them from the connector
at the rear of the backrest (6.2).
3. Insert the strap into the grooves of the seat backrest and seat
cover (6.3).
WASHING INSTRUCTIONS:
· The cover is removable and washable at
30º. Dry in the fresh air only.
· Wash in washing machine (cold).
· Do not use bleach.
· Dry clean, with any solvent except
trichloroethylene.
· Do not use dryer.
· Do not iron.
Removing the buckle protector and the lower harness
1.
Locate the safety buckle plate on the base of the seat (6.4).
2. Turn the plate of the belt safety buckle so that it matches the
groove and insert in the groove at the base of the seat and then
through the slots in the seat cover removing the safety buckle
from the seat (6.5).
3. Pull the straps at the base of the seat to remove them from
the seat, making sure the seat belt connectors are loosened as
shown in the instructions (6.6).
1. Wash the straps and plastic parts with neutral detergent and
warm water.
2.
Ensure that no soap enters the buckle or metal parts.
3.
Do not use chemicals or bleach on any part of the chair.
4.
Dry thoroughly before use.
If you have any question about using or installing this product, or if you need
a spare part contact our Customer Service.
Cleaning the seat
24 25
www.babyqs.com
BEZ123
Child restraint system
Group 1/2/3
EN