Operator’
s Manual
SMASH 24GT
34
Operations
5.2 Mounting tires
Note
: If mounting a tire starting from the bare rim,
clamp in place as described in section 5.1
Locking Rims.
5.2-1
5.2-2
5.2-3
5.2-4
Figure 5.2-1
•
Lubricate the entire rim surface.
Figure 5.2-2
•
Lubricate both beads of the tire, inside and outside,
with a tire
mounting paste
lubricant.
OBSERVE THE ROTATION DIRECTION OF THE TIRE,
IF REQUIRED. SOME TIRES HAVE A COLOR DOT
THAT MUST BE KEPT ON THE OUTSIDE OF THE
WHEEL.
LIBERAL LUBRICATION OF THE TIRE AND RIM IS
NECESSARY TO MOUNT THE TIRE AND OBTAIN
CORRECT ALIGNMENT ON THE RIM.
BE SURE YOU
ARE USING ONLY AN APPROVED MOUNTING
PASTE.
•
Rotate the rim until the valve is in the 5 o’clock
position.
•
Place the tire to be mounted on the rim.
•
Swing the mounting arm forward so that the mount/
demount tool is in the working position.
BEFORE BRINGING THE WORK ARM INTO THE
WORKING POSITION MAKE SURE THE MOUNT/
DEMOUNT TOOL IS NOT LOCKED IN A POSITION
SUCH AS TO KNOCK AGAINST THE EDGE OF THE
RIM.
Figure 5.2-3
•
Engage the lower bead OVER the mounting wing
and UNDER the mounting finger of the mounting tool.
•
Turn the wheel clockwise and push the tire down
into the drop center, opposite to the mount/demount
head (
Fig. 5.2-3
).
•
Mount the upper bead at the same way.
With low profile tyres the bead depressor tool “MX”
(optional EAA0247G70A) can help to facilitate
mounting of the top bead (
Fig. 5.2-4
).
http://www.atlas-tools.ru
АТЛАС
-
ОБОРУДОВАНИЕ
для
АВТОСЕРВИСА
+7 (863) 226-92-88
