22
Revision Date: 02/07/2020
Revision: C
Pre-Assembled Rhino - Installation Manual
Appendix 5: Installing the Roof Mounts on Tiled Roofs
Installing Roof Mounts on Tiled Roofs
This section provides steps for installing the Roof Mounts on tiled roofs. Before beginning please ensure you
have the following components for each Roof Mount that is to be installed:
Step 1:
Lift the tile above the line marked for the TOP Roof Mounts and slide
the LONG Roof Bracket between the two tiles in the valley of the
bottom tile. Ensure the Roof Bracket hooks onto the roof batten and
apply a generous bead of silicone underneath and on top of the Roof
Bracket to insulate it against the tile.
Step 2:
Lower the tile back down to lock the roof bracket into place.
Step 3:
Slide the bottom portion of the Roof Mount onto the installed Roof
Bracket, with the open rounded section facing the appropriate
orientation.
Step 4:
If installing the top of the system roof mounts, secure the bottom
portion of the Roof Mount in the desired location using appropriate
screws.
If installing the bottom of the system roof mounts, DO NOT fasten
them to the tile brackets so as to allow for thermal expansion and
contraction.
Step 5:
Lift the tile below and slide the SHORT Roof Bracket underneath until it
hooks onto the roof batten below (
Figure 2
). Lower the tile back down
to lock the roof bracket into place
Step 6:
Secure the SHORT Roof Bracket to the LONG Roof Bracket using two (2)
appropriate screws (
Figure 3
)
Step 7:
Repeat steps 1 to 6 until all top Roof Mounts are installed.
One (1) LONG Tiled Roof
Bracket
One (1) Short Tiled
Roof Bracket
Four (4) Button
Wafer Head
Screws
One (1) Lower Half of Roof
Mount
Figure 1
Figure 2
Figure 3
