Boss Snowplow RT3 DXT, Руководство по установке

Страница: 2 / 36

This product complies with all relevant European
directives; for details, please see the separate product
specific Declaration of Conformity (DOC) sheet.
BOSS Products limited consumer warranty and BOSS
Products commercial warranty policies are located
at www.BOSSPlow.com.
Patents pending.
Introduction
Note:
This manual is used for the assembly of all
BOSS DXT V-blade plows. Illustrations may vary.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.BOSSPlow.com for product safety and
operation training materials, accessory information,
help finding a dealer, or to register your product.
Whenever you need service, genuine BOSS parts, or
additional information, contact an Authorized BOSS
Dealer or BOSS Technical Service (1-800-286-4155)
and have the model and serial numbers of your
product ready.
Figure 1 identifies the location of the
model and serial numbers on the product. Write the
numbers in the space provided.
g271621
Figure 1
1. Model and serial number location
Date
Purchased
Model No.
Serial No.
Blade Crate
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(
Figure 2 ), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
g000502
Figure 2
Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
Contents
Safety ....................................................................... 3
Preparation......................................................... 3
Operation............................................................ 3
Safety and Instructional Decals .......................... 4
Installation ................................................................ 7
Installing the Blade and Push Frame................... 7
Installing the Trip Springs and Hydraulic
Cylinders......................................................... 8
Installing the Coupler Tower................................ 9
Installing the Hydraulic Hoses........................... 10
Installing the Light Bar .......................................11
Installing the Blade Guides and Filling the
Hydraulic Reservoir....................................... 12
Installing the Wire Harness ............................... 12
Installing the Headlight Adapters ...................... 16
Mounting the Plow Controller ............................ 17
Mounting the Snowplow.................................... 18
Adjusting the Pushbeam Height........................ 19
Leveling the Plow Blades.................................. 19
Aiming the Headlights....................................... 20
Product Overview ................................................... 21
Controls ........................................................... 21
Specifications .................................................. 23
Troubleshooting ...................................................... 24
Schematics ............................................................. 28
© 2019—BOSS Products
P.O. Box 787
Iron Mountain, MI 49801
2
Contact us at www.bossplow.com.
Printed in the USA
All Rights Reserved