Boss Snowplow RT3 DXT, Руководство по установке

Страница: 17 / 36

4. Connect the blue plug from the headlight adapter
to the blue plug on the long wire harness (
Figure
26 ).
5. Connect the free end of the headlight adapter to
the previously disconnected plug on the vehicle
wire harness (
Figure 26 ).
6. Repeat steps 1 through 5 on the right vehicle
headlight.
7. Continue the wire harness installation from step
5 of Installing the Wire Harness (page 12) .
For Four-Headlight Vehicles
1. Disconnect the wire harness plugs from the back
of the left vehicle headlights (
Figure 27 ).
g032933
Figure 27
1. Outer vehicle headlight 5. Blue plug
2. Headlight adapter 6. Headlight adapter
3. Inner vehicle headlight 7. Vehicle low-beam plug
4. Black plug 8. Vehicle high-beam plug
2. Connect the 2 ends of the headlight adapter to
the back of the left vehicle headlights (
Figure
27 ).
3. Connect the black plug from the headlight
adapter to the long wire harness (
Figure 27 ).
4. Connect the blue plug from the headlight adapter
to the blue plug on the long wire harness (
Figure
27 ).
5. Connect the free end of the headlight adapter to
the previously disconnected low-beam plug on
the vehicle wire harness (
Figure 27 ).
6. Grease, tuck, and secure the previously
disconnected high-beam plug on the vehicle
wire harness (
Figure 27 ).
Note:
You will not use this connector.
7. Repeat steps 1 through 6 on the right vehicle
headlights.
8. Continue the wire harness installation from step
5 of Installing the Wire Harness (page 12) .
Mounting the Plow
Controller
Mounting the Joystick Controller
Note:
Mount the controller in the cab in a dry area
where it does not interfere with vehicle operation or
visibility.
DANGER
The controller could cause serious injury if
contacted during a crash.
Mount the controller in a location that vehicle
occupants will not contact during a crash.
1. Determine the best location and configuration
for your controller mounting-bracket; refer to
Figure 28 for possible configurations.
2. Secure the mounting brackets to the vehicle
and joystick controller using 8 to 10 bolts (#8),
washers (#10), and nuts (#8) as shown in
Figure
28 .
3. Continue the wire harness installation from step
17 of Installing the Wire Harness (page 12) .
g273097
Figure 28
Mounting the SmartTouch2™
Controller
Note:
Mount the controller in the cab in a dry area
where it does not interfere with vehicle operation or
visibility.
17