Boss Snowplow RT3 DXT, Руководство по установке

Страница: 12 / 36

g036655
Figure 16
1. Cable ties 2. Short wire harness
7. Secure the wire harness to the light bar using 3
cable ties as shown in
Figure 16 .
Installing the Blade Guides
and Filling the Hydraulic
Reservoir
1. Attach the blade guides to the plow blade using
4 bolts (5/16 x 1 inch) and 4 self-locking nuts
(
Figure 17 ).
g212717
Figure 17
1. Self-locking nut (5/16 inch) 3. Bolt (5/16 x 1 inch)
2. Blade guide
2. Ensure that the lift cylinder is completely
collapsed.
Note:
The lights should tilt forward.
3. Remove the fill cap from the hydraulic reservoir
(
Figure 18 ).
g212210
Figure 18
1. Fill cap 2. Hydraulic reservoir
4. Slowly fill the reservoir with BOSS
high-performance hydraulic fluid until it
accepts no more.
Note:
The reservoir holds approximately 1.9 L
(2 US qt) of hydraulic fluid.
5. Install the previously removed fill cap.
Installing the Wire Harness
DANGER
Vehicle engines contain moving parts and can
become extremely hot, capable of causing
severe burns and serious bodily harm.
Shut off the engine and allow it sufficient time
to cool down before installing this kit.
DANGER
Vehicle batteries can cause dangerous
electrical shocks that could lead to severe
burns or death.
Disconnect your battery before installing this
kit. Remove the negative cable first, then
remove the positive cable.
12