Boss Snowplow RT3 DXT, Руководство по установке

Страница: 9 / 36

g271619
Figure 9
1. Bolt (5/8 inch) 3. Top locknut (5/8 inch)
2. Angle cylinder
7. Position the plow blades into a “V” shape.
8. Hook the 2 return springs through the holes on
the top of the blade center (
Figure 10 ).
g271609
Figure 10
1. Self-locking nut (1/2 inch) 5. Bolt (5/8 inch)
2. Washer (1/2 inch) 6. Top locknut (5/8 inch)
3. Eyebolt 7. Angle cylinder
4. Return spring
9. Hook the other ends of the return springs to 2
eyebolts (
Figure 10 ).
10. Insert the threaded end of the eyebolts through
the holes on the plow blade and secure them
using 2 washers (1/2 inch) and 2 self-locking
nuts (
Figure 10 ).
11. Tighten the self-locking nuts until there is a gap
of 0.8 mm (1/32 inch) between the return spring
coils.
12. Slide a push nut retainer onto each end of the
return springs.
13. Secure the 2 angle cylinders to the blade wings
using a bolt (5/8 inch) and top locknut (
Figure
10 ).
Installing the Coupler
Tower
1. Align the pivot holes of the coupler tower with
the pivot holes on the pushframe, and secure
them with a clevis pin (1 inch), flat washer (1
inch), bolt (3/8 x 1-1/2 inches), washer (3/8
inch), and locknut (
Figure 11 ).
g271610
Figure 11
1. Bolt (3/8 x 1-1/2 inches) 4. Flat washer (1 inch)
2. Washer (3/8 inch) 5. Coupler tower
3. Locknut (3/8 inch) 6. Clevis pin (1 inch)
2. Secure the free end of the lift cylinder to the
coupler tower using a clevis pin (5/8 inch) and
hairpin cotter (
Figure 12 ).
9