Boss Snowplow RT3 DXT, Руководство по установке

Страница: 19 / 36

5. Push the SmartHitch2 switch on the side of the
coupler tower upward and raise the tower until
the coupler spring pins snap in (
Figure 32 ).
g033004
Figure 32
1. SmartHitch2 switch 3. Coupler spring pin
2. Coupler tower
6. Ensure that both coupler spring pins have fully
engaged the coupler (
Figure 31 ).
Note:
Move the coupler tower until the spring
pins engage completely.
7. Switch the headlight toggle switch to the P
LOW
position.
Adjusting the Pushbeam
Height
Optional
1. Measure the distance from the ground to the
coupler spring-pin holes on the undercarriage
pushbeam (
Figure 33 ). The measurement
should match the height listed for your plow in
Specifications (page 23) .
2. If the pushbeam is not at the correct height,
remove the fasteners securing the pushbeam to
the undercarriage (
Figure 33 ).
3. Move the pushbeam up or down and secure it
with the previously removed hardware.
4. Torque the fasteners to 76 N∙m (56 ft-lb).
g230889
Figure 33
1. Measure this distance. 2. Fastener
Leveling the Plow Blades
1. Loosen and carefully remove the 4 lock nuts and
4 washers from the trip-spring eye bolts (
Figure
34 ).
g033911
Figure 34
1. Locknut and washer 3. Spring yoke
2. Trip spring
2. Adjust the bumper-stop plate ( Figure 35 ).
Note:
Slide the plate in to lower the center of
the plow; slide the plate out to raise the center
of the plow.
19