Boss Snowplow RT3 DXT, Руководство по установке

Страница: 20 / 36

g032940
Figure 35
1. Bolt 3. Bumper stop
2. Bumper-stop plate 4. Push frame
3. Secure the plate to the bumper stop and push
frame using the previously removed bolt (
Figure
35 ). Torque the bolt to 31 N∙m (23 ft-lb).
Aiming the Headlights
Important:
Certify that the installation of the
snowplow lights conforms to applicable federal
motor vehicle safety standards.
1. Park the vehicle on a level surface 7.5 m (25 ft)
away from a matte white screen or garage door.
Note:
The screen should be perpendicular to
both the ground and the front of the vehicle.
2. Ensure that the vehicle is equipped for normal
operation with the snowplow attached and in the
raised position.
3. Perform the following actions to ensure optimal
headlight alignment:
•
Remove any ice or mud from under the
fenders.
•
Ensure that all tires are fully and evenly
inflated.
•
Check vehicle springs for sag or broken
leaves.
•
Check the function of any level ride controls.
•
Stabilize the suspension by rocking the
vehicle sideways.
•
Ensure that there is no load in the vehicle
other than the driver.
•
Clean the headlights and matte white screen.
4. Mark the vertical vehicle centerline on the
screen (
Figure 36 ).
g032936
Figure 36
1. Vertical left headlight
centerline 5. Brightest points
2. Vehicle centerline 6. Distance between
headlight centers
3. Vertical right headlight
centerline 7. Distance from ground to
headlight centers
4. Horizontal headlight
centerline
5. Mark the vertical headlight centerline on the
screen (
Figure 36 ).
6. Mark the horizontal headlight centerline on the
screen (
Figure 36 ).
Note:
The horizontal headlight centerline
should be the distance from the ground to the
center of the headlight.
7. Adjust the plow headlights until the brightest
part of the plow low-beam lights are aligned as
shown in
Figure 36 .
8. Tighten the 4 bolts (1/4 x 3/4 inch) securing each
headlight to the headlight brackets and torque
them to 8 N∙m (6 ft-lb).
Important:
Do not use thread locking
compound on these bolts.
9. Tighten the bolt (3/8 x 1 inch) securing each
headlight-bracket to the light bar and torque
them to 31 N∙m (23 ft-lb).
Important:
Do not use thread locking
compound on these bolts.
20