Bosch VIP X1, Инструкция по установке и эксплуатации

Страница: 20 / 144

EN | 20 Installation and Operating Manual | VIP X1
Installation Bosch Security Systems | 2006-12 | V2.5
Connections
Cameras
You can connect one video source to the VIP X1. Any cameras and other video
sources that produce a standard PAL or NTSC signal are suitable.
– Connect the camera or another video source with a video cable (75 Ohm,
BNC connector) to the BNC Video In sockets.
– If the video signal is not looped through, termination is performed by a soft-
ware setting if necessary (see Video input , page 46).
Audio connections (audio version only)
The audio version of the VIP X1 has two audio ports for audio line signals as well
as a microphone input and a loudspeaker output.
The audio signals are transmitted two-way and in sync with the video signals.
As a result, you can connect a speaker or door intercom system at the destina-
tion point, for example.
Note
If possible you should use the line ports of the intercom for transmitting au-
dio signals on the intercom systems. The following specifications should
be complied with in all cases.
Line In: Impedance 9 kOhm typ., 5.5 V
p-p
max. input voltage
Line Out: Impedance 16 Ohm min., 3 V
p-p
max. output voltage
MIC (microphone): Impedance 2 kOhm typ., 2.8 V
p-p
max. input voltage,
–20 dB in, supply 2.3 V typ.
SPK (speaker): Impedance 4 Ohm min., 6 V
p-p
max. output voltage,
power output RMS 1 W