44
en | Configuration
FLEXIDOME indoor 5100i (IR) | FLEXIDOME
outdoor 5100i (IR)
11-2022 | V02 | F.01U.394.427
User manual
Bosch Security Systems B.V.
4.6.7
Alarm Task Editor
Editing scripts on this page overwrites all settings and entries on the other alarm pages. This
procedure cannot be reversed.
To edit this page, you should have programming knowledge and be familiar with the
information in the Alarm Task Script Language document and the English language.
As an alternative to the alarm settings on the various alarm pages, enter the desired alarm
functions in script form here. This will overwrite all settings and entries on the other alarm
pages.
1.
Click
Examples
under the Alarm Task Editor field to see some script examples. A new
window opens.
2.
Enter new scripts in the Alarm Task Editor field or change existing scripts in line with your
requirements.
3.
When finished, click
Set
to transmit the scripts to the device. If the transfer was
successful, the message
Script successfully parsed.
is displayed over the text field. If it
was not successful, an error message is displayed with further information.
4.7
Network
The settings on these pages are used to integrate the device into a network. Some changes
only take effect after a reboot. In this case
Set
changes to
Set and Reboot
.
1.
Make the desired changes.
2.
Click
Set and Reboot
.
The device is rebooted and the changed settings are activated.
4.7.1
Network Services
This page shows an overview of all available network services. Use the checkbox to activate or
deactivate a network service. Click on the settings symbol next to the network service to go to
the settings page for this network service.
Click
Set
to apply the changes.
Some changes only take effect after the unit is rebooted. In this case, the
Set
button changes
to
Set and Reboot
.
4.7.2
Network Access
If the IP address, subnet mask, or gateway address is changed, then the device is only
available under the new addresses after the reboot.
IPv4
Automatic assignment (DHCP)
If the network has a DHCP server for the dynamic assignment of IP addresses, select
On
to
automatically accept the DHCP-assigned IP address.
For certain applications, the DHCP server must support the fixed assignment between IP
address and MAC address, and must be appropriately set up so that, once an IP address is
assigned, it is retained each time the system is rebooted.
IP address
Enter the desired IP address for the camera. The IP address must be valid for the network.
Subnet mask
Enter the appropriate subnet mask for the set IP address.
Gateway address
For the device to establish a connection to a remote location in a different subnet, enter the IP
address of the gateway here. Otherwise, this field can remain empty (0.0.0.0).
