46
en | Configuration
FLEXIDOME indoor 5100i (IR) | FLEXIDOME
outdoor 5100i (IR)
11-2022 | V02 | F.01U.394.427
User manual
Bosch Security Systems B.V.
Discovery port (0 = Off)
Enter the number of the port that you want to discover.
To deactivate the port, enter 0.
Interface mode ETH
If necessary, select the Ethernet link type for interface ETH. Depending on the device
connected, it may be necessary to select a special operation type.
Network MSS [Byte]
Set the maximum segment size for the IP packet's user data here. This gives the option to
adjust the size of the data packets to the network environment and to optimize data
transmission. In UDP mode, comply with the MTU value set below.
Network MTU [Byte]
Specify a maximum value in bytes for the package size (including IP header) to optimize data
transmission.
Click
Set
to apply the changes.
4.7.3
Advanced
RTSP
RTSP port
If necessary, select a different port for the exchange of the
RTSP
data from the list. The
standard
RTSP port
is 554. Select
Off
to deactivate the
RTSP
function.
TCP metadata input
TCP port
The device can receive data from an external TCP sender, for example an ATM or POS device,
and store it as metadata. Select the port for TCP communication. Select
Off
to deactivate the
function.
Sender IP address
Enter a valid
Sender IP address
.
Syslog
Server IP address
Enter the appropriate IP address of the server.
Server port (0 = Off)
Enter the number of the server port.
Protocol
Select the appropriate protocol:
UDP
,
TCP
, or
TLS
.
Click
Set
to apply the changes.
4.7.4
Network Management
SNMP
The camera supports two versions of Simple Network Management Protocol (SNMP) for
managing and monitoring network components, and can send SNMP messages (traps) to IP
addresses. The unit supports SNMP MIB II in the unified code.
Select either of the options that follow for the
SNMP
parameter:
–
SNMP v1 legacy
–
SNMP v3
If you select either of the SNMP version, but do not enter an SNMP host address, the camera
does not send messages (traps) automatically, but only replies to SNMP requests.
Select
Off
to deactivate the SNMP function.
