Borri ASD10, Руководство по эксплуатации

Страница: 51 / 187

Installation and start-up of UPS B9000FXS
Installazione e avviamento B9000FXS
34 OMD10081 REV. I
5.2 START-UP PROCEDURE
EPO push-button and phase rotation
Before switching the UPS on, make sure that:
1) the emergency power off “EPO” push-button, if installed, is not pressed. If not,
press it back to the rest position;
2) the input and output phase rotation is correct.
Circuit breaker BCB
Battery circuit breaker BCB is external to the UPS system.
Do not close the battery breaker BCB before it’s required by the front panel. Serious
damages to the UPS internal parts and/or to the battery may occur.
No. LCD DISPLAY ACTION OPERATING CHECKS
1 BLANK
Close RCB
A few seconds after the closing of input
circuit breaker RCB the pre-charging phase
of the capacitive bank will start. The control
logic will be started and the front panel will
be activated.
2 BOOT LOADING “BOOT” phase where the UPS firmware can
be updated following the appropriate
procedure. All the LED’s on the front panel
are on.
3 EEPROM READING Reading of the configuration parameters
stored in the EEPROM.
All the LED’s on the front panel are off.
4 UPS START UP
WAIT PLEASE
UPS start-up. LED #1 is on - input voltage
present.
5 RECTIFIER START UP
WAIT PLEASE
The IGBT rectifier bridge starts to modulate;
VDC voltage reaches the nominal value.
LED #3 is lit green: DC voltage present.
6 INVERTER START
WAIT PLEASE
The modulation of the inverter bridge is
started. The AC output voltage reaches the
nominal value. After a few seconds the static
inverter switch is closed. LED #5 is lit
green: static switch SSI closed.
7 BYPASS START UP
CLOSE SBCB
Close SBCB