Bongshin BS-235, Инструкция по эксплуатации

Страница: 57 / 69

55
5. Command to send the Low/High limit values (
rLY.1H/rLY.1L, rLY.2H/rLY.2L, rLY.3H/rLY.3L)
Check the set Lo/Hi value through communication.
Command example
ID COMMAND
1 2 3 4
5
6 7 8
<STX> 0 1 R
Y
1 H <ETX>
<STX> 0 1 R
Y
I L <ETX>
<STX> 0 1 R Y 2 H <ETX>
<STX> 0 1 R Y 2 L <ETX>
<STX> 0 1 R Y 3 H <ETX>
<STX> 0 1 R Y 3 L <ETX>
Response example (with decimal point)
ID COMMAND
Sign
VALUE
1 2 3 4
5
6 7 8 9 10 11 12 13 14 15
<STX> 0 1 R
Y
1 H + 0 2 . 0 0 0 <ETX>
<STX> 0 1 R
Y
1 L + 0 2 . 0 0 0 <ETX>
<STX> 0 1 R Y 2 H + 0 4 . 0 0 0 <ETX>
<STX> 0 1 R Y 2 L + 0 4 . 0 0 0 <ETX>
<STX> 0 1 R Y 3 H + 0 6 . 0 0 0 <ETX>
<STX> 0 1 R Y 3 L + 0 6 . 0 0 0 <ETX>
Response example (without decimal point) : number of digits is reduced by one.
ID COMMAND
Sing
VALUE
1 2 3 4 5 6 7 8 9 10 11 12 13 14
<STX> 0 1 R Y 1 H + 0 2 0 0 0 <ETX>
<STX> 0 1 R Y 1 L + 0 2 0 0 0 <ETX>
<STX> 0 1 R
Y
2 H + 0 4 0 0 0 <ETX>
<STX> 0 1 R
Y
2 L + 0 4 0 0 0 <ETX>
<STX> 0 1 R
Y
3 H + 0 6 0 0 0 <ETX>
<STX> 0 1 R Y 3 L + 0 6 0 0 0 <ETX>
Data reception, command, and response toward command differ based on ID setting and location of
decimal point
.
Serial output and command setting can be conducted even under hold status (only zero command cannot be operated)
Command setting is available even under stream mode setting (operation of zero command is also available)
However, since data may be broken due to overlapping thus it would be better not to use command under stream
mode status.
Data reception or response is unavailable during entry to function mode (same for stream mode).
Response to command is unavailable during entry to function mode, calibration mode, and relay mode. (same for
stream mode)
In case of using RS‐232C/422 serial output, command is operated even under stream mode.
(operation is unavailable for RS‐485).
In case of using RS‐422, RS‐485 shall be changed into RS‐422 at function mode.