BOMBARDIER Sea-Doo SPORTSTER LE, Дополнение к руководству по эксплуатации

Страница: 98 / 122

Section 08 ELECTRICAL SYSTEM
Subsection 03 (IGNITION SYSTEM)
08-03-4
LMR2000_066_08_03A.FM
6. From this point, rotate flywheel clockwise to
reach proper specification according to engine.
Refer to the following chart.
7. Scribe a thin temporary mark on PTO flywheel
aligned with timing mark pointer tool tip.
TYPICAL
1. Tool tip
2. Flywheel mark
NOTE: This mark will become the reference when
using the stroboscopic timing light.
CAUTION: The static test cannot be used as a
timing procedure, therefore, always check the
timing with a stroboscopic timing light.
8. Remove TDC gauge.
9. Reinstall spark plug and connect wire.
Dynamic Test
To check ignition timing, use Bombardier timing
light (P/N 529 031 900).
1. Connect an induction-type tachometer (P/N 295
000 100) to spark plug wire.
1. Tachometer pick-up
2. Connect timing light pick-up to MAG side spark
plug wire.
1. Timing light pick-up
ENGINE
IGNITION TIMING
(BTDC)
947 2.99 mm (.118 in)
F04H6VA
1 2
A00B4FA
F06H06A
1
F00H0HA
1