BOMBARDIER Sea-Doo SPORTSTER LE, Дополнение к руководству по эксплуатации

Страница: 79 / 122

Section 05 COOLING SYSTEM
Subsection 02 (CIRCUIT, COMPONENTS AND CARE)
LMR2000_056_05_02A.FM
05-02-7
Pull the valve slightly. Using pliers, release the
clamp which retains the bellows
no. 8 .
Remove valve no. 9 and bellows.
Loosen clamp to separate valve from bellows.
1. Clamp
Inspection
Inspect parts for damage. Verify especially bel-
lows for cracks.
Assembly
Assembly is essentially the reverse of disassem-
bly procedures.
Towing the Boat in Water
Special precautions should be taken when towing
a Sea-Doo sport boat in water.
Maximum recommended towing speed is 24 km/h
(15 MPH).
When towing your sport boat in water, pinch the
water supply hose from the jet pump housing to
the engine with a large hose pincher (P/N 529 030
400).
This will prevent the cooling system from filling
which may lead to water being injected into and
filling the exhaust system. Without the engine run-
ning there isn’t any exhaust pressure to carry the
water out the exhaust outlet.
CAUTION: Failure to do this may result in dam-
age to the engine. If you must tow a stranded
boat in water and do not have a hose pincher
be sure to stay well below the maximum tow-
ing speed of 24 km/h (15 MPH).
Snugly install the hose pincher on the water sup-
ply hose as shown in the following illustration.
PINCH WATER SUPPLY HOSE (LARGE ONE ONLY)
1. Pinch large hose here
CAUTION: When finished towing the sport
boat, the hose pincher must be removed before
operating it.
F01E21A
F01E24A
1
F01B23A
1
F04M02A