BOMBARDIER Sea-Doo SPORTSTER LE, Дополнение к руководству по эксплуатации

Страница: 101 / 122

Section 08 ELECTRICAL SYSTEM
Subsection 03 (IGNITION SYSTEM)
LMR2000_066_08_03A.FM
08-03-7
NOTE: To perform verification, a good quality mul-
timeter such as Fluke 73 (P/N 529 022 000) should
be used.
Engine Start/Stop Switch Verification
Disconnect the YELLOW/RED wire of the start/
stop switch. Using an ohmmeter, connect test
probes to YELLOW/RED wire and to ground.
Measure resistance, it must be an open circuit
(switch is normally open). Depress and hold switch,
the ohmmeter should read close to 0 ohm.
Safety Lanyard Switch Verification
If 2 short beeps are not heard when installing the
safety lanyard, refer to DIGITALLY ENCODED SE-
CURITY SYSTEM.
The following continuity tests can also be per-
formed using an ohmmeter:
Disconnect switch wires.
Safety Lanyard Removed
Connect test probes to switch BLACK and BLACK/
YELLOW wires. Measure resistance, there should
be no continuity (open circuit).
Connect one test probe to the WHITE/GRAY wire
and the other test probe to the switch terminal.
Measure resistance, it must be close to 0 ohm.
Connect one test probe to the BLACK wire and the
other test probe to the switch ring. Measure resis-
tance, it must be close to 0 ohm.
Safety Lanyard on Switch
Connect test probes to switch BLACK and BLACK/
YELLOW wires. Measure resistance, it must be
close to 0 ohm.
Timer Verification
The timer is integrated into the MPEM.
Always confirm first that the fuses are in good
condition.
To confirm operation of timer, remove safety lan-
yard from switch. After a 5 seconds delay, depress
start/stop button once. The timer should stay on
for about 33 seconds (for example, gauge(s) will
be activated) and then turn off.
Rev Limiter Verification
To check engine rev limiter, connect an induction
tachometer (P/N 295 000 100), start engine and
check its maximum speed.
Trigger Coil Verification
STATIC TEST: CONTINUITY
1. Disconnect magneto wiring harness connector.
2. Install the 6-pin magneto harness adapter (P/N
295 000 136).
3. Connect one of the multimeter probes to the
WHITE wire of the 6-pin magneto harness
adapter.
4. Connect the other multimeter probe to the BLACK/
YELLOW wire of the 6-pin magneto harness
adapter.
5. Measure resistance; it should be between 190-
300 ohms.
1. Multimeter
2. Six-pin magneto harness adapter
3. WHITE wire
4. BLACK/YELLOW wire
MODEL
RPM LIMITER
SETTING
Sportster LE 7200 ± 50
F01B28A
F01H5YA
1 2 3 4