BOMBARDIER Sea-Doo SPORTSTER LE, Дополнение к руководству по эксплуатации

Страница: 104 / 122

Section 08 ELECTRICAL SYSTEM
Subsection 07 (CHARGING SYSTEM)
08-07-2
LMR2000_068_08_07A.FM
Stator
STATIC TEST: CONTINUITY
1. Disconnect the magneto wiring harness con-
nector.
2. Install the 6-pin magneto harness adapter (P/N
295 000 136).
3. Check resistance between two of the YELLOW
wires. The resistance should be between 0.1 to
1.0 ohm.
1. Multimeter
2. Magneto harness adapter
3. YELLOW wires
4. Place either meter lead into the remaining YEL-
LOW wire and note the resistance (same as
step no. 3). If the readings are out of specifica-
tion, the stator will need to be replaced.
STATIC TEST: INSULATION
1. Disconnect the magneto wiring harness con-
nector.
2. Install the 6-pin magneto harness adapter (P/N
295 000 136).
3. Insert multimeter positive (+) probe to one of
the YELLOW wire of the 6-pin magneto harness
adapter.
4. Ground the multimeter negative (-) probe to the
engine or the stator iron core and note the read-
ing.
1. Multimeter
2. Magneto harness adapter
3. Positive (+) probe to YELLOW wire
4. Negative (-) probe to ground
5. Repeat test with the other two YELLOW wires
of the 6-pin magneto harness adapter.
NOTE: There should be no continuity (infinity) be-
tween the stator insulated coils and ground. If
there is a reading, the stator coils and/or the wiring
from the coils is grounded and needs to be re-
placed or repaired.
DYNAMIC TEST
1. Disconnect the magneto wiring harness con-
nector.
2. Install the 6-pin magneto harness adapter (P/N
295 000 136).
3. Connect test probes of the multimeter to two
of the YELLOW wires of the 6-pin magneto har-
ness adapter.
4. Set multimeter to Vac scale.
5. Start and rev engine to 3500 RPM. The obtained
value should be between 45 and 70 Vac.
6. If the stator is out of specification, replace it.
F01H5ZA
1 3
3 2
F01H60A
1
3
2
4