BOMBARDIER DS 650, Руководство по ремонту

Страница: 233 / 248

Section 10 BODY/FRAME
Subsection 02 (BODY)
VMR2004_029_10_02A.FM
10-02-9
TYPICAL
1. Piece of wood
2. ETN-50 (electric) or T-50 (manual)
After cover installation cut the excess of material
all around the seat.
SEAT CLEANING
It is recommended to clean the seat with a solu-
tion of
warm soapy water , using a soft clean
cloth.
CAUTION: Avoid use of harsh detergents such
as strong soaps, degreasing solvents, abrasive
cleaners, paint thinners, etc. that may cause
damage to the seat cover.
DECALS REPLACEMENT
Removal
Using a heat gun warm up one end of decal for a
few seconds until decal can roll off when rubbing
with your finger.
Pull decal slowly and when necessary apply more
heat to ease removal on the area that has to be
peeled off.
If decal tears while pulling off, it has to be heated
for a few seconds longer. If decal tends to stretch
while pulling off, stop heating and wait a few sec-
onds to let it cool, then peel it off.
Installation
There are 2 types of decals used on ATV’s. One
has a protective film on back side and the other
has a protective film on both sides. They are used
on 2 types of materials; plastic and metal.
Decals Having a Protective Film
on Back Side Only
These decals usually contain written information
(ex.: warning).
Clean surface with a good solvent such as ACRYL-
ICLEAN DX 330 from PPG or equivalent (refer to
manufacturer instructions).
Using a pencil and the decal as a template, mark
the area where decal will be located.
Remove half of the decal back protective film and
align decal with marks. Start sticking it from center
and remove the other half of the film to stick it
completely. Carefully squeegee decal beginning at
center and working outward using, firm, short,
overlapping strokes.
Decals Having a Protective Film on Both Sides
These decals usually contain graphics.
Installation on Plastic
Clean surface with isopropyl alcohol.
Using a pencil and the decal as a template, mark
the area where decal will be located.
Apply an activator (P/N 293 530 036) to prepare the
surface using a clean cloth. After a few seconds,
when the activator evaporates, the surface is ready.
CAUTION: Do not use soapy water to locate de-
cal on plastic parts.
Remove back protective film from decal and care-
fully align decal with marks. When well aligned
squeegee decal beginning at center and working
outward using firm, short, overlapping strokes.
PLASTIC
MAINTENANCE/REPAIR
MAINTENANCE
Clean the vehicle thoroughly, removing all dirt and
grease accumulation.
To clean use a soft clean cloth and either soapy
water or isopropyl alcohol.
To remove grease, oil or glue use isopropyl alcohol.
CAUTION: Do not apply isopropyl alcohol or ac-
etone directly on decals.
F01L3YA
2
1