BNF Blade 500 3D, Инструкция по эксплуатации

Страница: 3 / 64

3
EN
Table of Contents
Blade 500 3D Specifications
Length
33.5 in (850mm)
Height
11.8 in (300mm)
Main Rotor Diameter
38.2 in (970mm)
Tail Rotor Diameter
7.8 in (200mm)
Flying Weight
4.06 lb (1842 g)
Components
Motor
520H Brushless outrunner, 1320Kv (installed)
ESC
70-amp brushless (installed)
Battery
6S 22.2V 2900mAh 30C Li-Po (included with RTF)
Charger
DC Li-Po Balancing Charger (included with RTF)
Transmitter
Spektrum™ DX6i 6-channel Computer Radio with
AA Batteries (included with RTF)
Receiver
Spektrum AR6210 6-Channel DSMX® Receiver
(installed)
Swash Servos
Spektrum S300 (installed)
Tail Servo
Spektrum S400G (installed)
Gyro
G210 MEMS Heading Lock (installed)
To register your product online, visit www.bladehelis.com
Charging the Flight Battery ...........................................................................4
Battery Charging Codes ................................................................................4
Charging Warnings........................................................................................5
Throttle Hold .................................................................................................5
Transmitter Setup .........................................................................................6
Transmitter and Receiver Binding ..................................................................9
Installing the Flight Battery ...........................................................................9
Rudder Control Test ....................................................................................10
Cyclic Control Test ......................................................................................10
Motor Control Test .......................................................................................11
Blade 500 3D Pre-Flight Checklist...............................................................11
Choosing a Flying Location .........................................................................11
Flying the Blade 500 3D .............................................................................11
Low Voltage Cutoff (LVC) .............................................................................12
Flight Guidelines and Warnings ...................................................................12
Adjusting the Drive Belt Tension ..................................................................12
Post-Flight Inspections and Maintenance ....................................................12
Maintenance check list ...............................................................................12
Blade 500 3D Post-Crash Check List ...........................................................13
Limited Warranty and Contact Information ..................................................13
AMA National Model Aircraft Safety Code ....................................................14
FCC Information ..........................................................................................14
Compliance Information for the European Union ..........................................15
Parts List ....................................................................................................59
Optional Parts .............................................................................................61
WARNING: This helicopter is equipped with carbon fiber blades that spin at very
high RPM. Always follow all safety precautions found in this manual.
*Transmitter, Li-Po, AA Batteries and Charger not included with BNF Basic Version
500 3D
BLH1800 BLH1850
RTF