BMW 525I SEDAN, Руководство пользователя

Страница: 97 / 223

Controls
95
Reference
At a glance
Driving tips
Communications
Navigation
Entertainment
Mobility
Practical interior accessories
Integrated universal remote
control
*
The concept
The integrated universal remote control
can replace as many as three hand-held
transmitters for various remote-controlled
accessories, such as door openers and
house alarm systems. The integrated uni-
versal remote control registers and stores
signals from the original hand-held trans-
mitters.
The signal of an original hand-held trans-
mitter can be programmed on one of the
three memory buttons
1 . Following that,
each of the devices can be actuated with
the appropriately programmed memory
button
1
. The indicator lamp
2
flashes to
confirm transmission of the signal.
Should you sell your vehicle one day, be
sure to delete the stored programs before-
hand for your safety, refer to page
96 .
To prevent possible damage or injury,
before programming or using the inte-
grated universal remote control, always
inspect the immediate area to make certain
that no people, animals or objects are
within the travel range of the device. Also,
comply with the safety precautions of the
original hand-held transmitter.
<
Checking compatibility
If you see this symbol on the pack-
aging or in the manual supplied with
the original hand-held transmitter, it
is safe to assume that it is compatible with
the integrated universal remote control.
If you have additional questions,
please consult your BMW center or
call 1-800-355-3515.
You can also visit these websites:
www.bmwusa.com or
www.homelink.com.
HomeLink is a registered trademark owned
by Johnson Controls, Inc.
<
Programming
1 Memory buttons
2 Indicator lamp
Fixed-code hand-held transmitter
1. Ignition key in position 2
2. When using for the first time: Press both
outer buttons
1 for approx. 20 seconds
until the indicator lamp
2
flashes. The
three memory buttons 1 are cleared
3. Hold the original hand-held transmitter
at a distance of approx. 2 in/5 cm to
8 in/20 cm to the memory buttons
1
The required distance between
the hand-held transmitter and the
memory buttons 1 depends on the rele-
vant system of the original hand-held
transmitter used.
<
4. Simultaneously press the transmit key
on the original hand-held transmitter
and the desired memory button
1 on
the integrated universal remote control.
Initially, the indicator lamp
2
flashes
slowly. Release both buttons as soon
as the indicator
2 lamp flashes rapidly.
If the indicator lamp 2 does not flash
rapidly after approx. 15 seconds,
change the distance
5. To program other original hand-held
transmitters, repeat steps 3 and 4.
The corresponding memory button
1
is now
programmed with the signal of the original
hand-held transmitter.
Online Edition for Part No. 01 41 0 158 159 - © 02/04 BMW AG