BMW 525I SEDAN, Руководство пользователя

Страница: 186 / 223

Replacing components
184
Lamps in luggage compartment lid
License plate lamp
Bulb 5 watts, C 5 W
1. Insert a screwdriver in the slot and
press to the right, refer to arrows; thus
unlocks the lamp
2. Remove the lamp and replace the bulb.
Backup lamps
Please contact a BMW center in case of a
malfunction.
Light-emitting diodes LEDs
Light-emitting diodes installed behind
translucent lenses serve as the light source
for many of the controls and displays in
your vehicle. These light-emitting diodes,
which operate using a concept similar to
that applied in conventional lasers, are offi-
cially designated as Class 1 light-emitting
diodes.
Do not remove the covers, and never
stare into the unfiltered light several
hours, as irritation of the retina could
result.
<
Changing wheels
Safety measures in the event of a
breakdown or wheel change:
Park the vehicle as far away as possible
from moving traffic and on firm ground.
Switch on the hazard warning flashers.
Lock the steering wheel in straight-ahead
setting of the wheels. Apply the handbrake
and engage first gear, reverse gear or
selector-lever position P.
Have all vehicle occupants get out of the
vehicle and ensure that they remain outside
the immediate area in a safe place, such as
behind a guardrail.
If a warning triangle or portable hazard
warning lamp is required, set it up on the
roadside at an appropriate distance from
the rear of the vehicle. Comply with all
safety guidelines and regulations.
Change the wheel only on a level, firm sur-
face which is not slippery. The vehicle or
the jack could slip to the side if you attempt
to raise the vehicle on a soft or slippery sur-
face such as snow, ice, tiles, etc.
Position the jack on a firm support surface.
Do not use a wooden block or similar
object as a support base for the jack, as
this would prevent it from extending to its
full support height and reduce its load-car-
rying capacity.
To avoid serious or fatal injury: never lie
under the vehicle, and never start the
engine while it is supported by the jack.
<
What you will need
To avoid rattling noises later on, note the
positions of the tools before removing
them, then return them to their initial posi-
tions after completing work.
1 Chock
2
Vehicle jack
3 Lug wrench
are located in the tool space in the com-
pact wheel.
1. Lift up floor mat or floor panel flap and
cover located below it
2. Take out the required tool(s)
3. After using the tools, return then to the
storage space.
Online Edition for Part No. 01 41 0 158 159 - © 02/04 BMW AG