blupura WAVE HOT, Руководство по эксплуатации и обслуживанию

Страница: 3 / 36

3
Precautions and general recommendations
This appliance is intended to be used in household and similar
applications such. Appliance for internal use only. Place the
unit away from water jets.
Always connect the water cooler to a water main that supplies
drinking water only.
Before each installation, the unit must be sanitized by an
authorized technician.
After installation, ensure that the unit is not resting on the
power cable.
Check that the unit is level and that it is resting on a floor with
sufficient load-bearing capacity, in an environment that is suitable for its dimensions and its
use.
Before any maintenance or cleaning operation is carried out, remove the plug from the
socket or disconnect the power supply.
Ensure that the product is not sited close to sources of heat.
To guarantee adequate ventilation, leave at least 10 cm of space around the unit.
Install the product in a clean, dry, well-ventilated environment. The product is designed
to function in environments with a temperature range of between 5°C and 32°C - Climate
Class N.
Take care not to damage the cooling fluid circuit: it is filled with R290, which is a highly
flammable gas. It is essential to ensure that the tubes of the refrigerant circuit are not
damaged.
Ensure that it is possible to disconnect the power supply either by removing the plug or via
a two-pole circuit-breaker, with an opening distance of the contacts that allows complete
disconnection in the conditions of overvoltage category III, placed upstream of the plug.
Check that the voltage shown on the serial number plate corresponds to the voltage being
supplied at the installation site.
The unit must not be cleaned with a water jet. Do not position other electrical equipment in
the immediate vicinity of the water cooler.
Turn off the main water inlet tap if the unit is not to be used for a long period.
Keep the areas surrounding the unit dry to avoid the risk of people slipping.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person in order to avoid a hazard. Do not use extension
leads or adapters.
This appliance is intended to be used by persons (including children aged from 8
years) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, provided that they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance. The appliance is only to
be installed in locations where it can be overseen by trained personnel.
The Appliance shall be protected by a ground-fault circuit interrupter.
This equipment is to be installed in compliance with the local plumbing codes. Water
pipe connections and fixtures directly connected to a potable water supply shall be
sized, installed, and maintained in accordance with federal, state, and local codes.
This publication is based on information available when approved for printing. Continuing
design refinements could cause changes that may not be included in this publication.