6
Service Procedures
16
©
Moffat Ltd, January 2007
Revision 1/
Blue Seal Evolution Series Gas Salamander
6.2.2 Pilot
burner
6.2 Replacement
6.2.1 Thermocouple
1) Remove control knob.
2) Undo the two screws at the bottom of the
control panel, and remove.
6.1.1 Control
panel
6.1 Access
Figure 6.2.1
Figure 6.1.1
Two screws
6.1.2 Side
panel
1) Undo the two screws near the bottom of the
side panel to be removed.
2) Lift the side panel and remove from the
salamander.
Figure 6.1.2
Two screws
Clamp
1) Remove the side panel (refer 6.1.2).
2) Unscrew the thermocouple from the rear of
the gas control.
3) Undo the clamp on the pilot burner holding
the thermocouple in place (secured by one
screw). Withdraw the thermocouple from the
pilot assembly.
4) Replace and reassemble in reverse order.
IMPORTANT:
WHEN SCREWING THERMOCOUPLE BACK
INTO THE GAS CONTROL, ONCE THREADED
UP, TIGHTEN UP ANOTHER ¼ TURN ONLY.
DO NOT OVER TIGHTEN.
1) Remove the side panel (refer 6.1.2)
2) Undo the pilot supply tube from either the
pilot burner or the gas control valve.
Pilot supply tube
Figure 6.2.2a
