Blue Seal G576, Инструкция по установке и эксплуатации

Страница: 20 / 26

18
Gas Conversion and Specifications
Oven
Main Injector
1. With the gas supply turned off at the main supply,
unscrew and remove the 6 screws securing the lower
lintel to the front of the oven.
2. Remove the lintel from the oven.
3. Open the oven door and remove the cast sole plate
from inside the oven. (Refer to Fig 15).
4. Remove the screw securing the oven burner to the
floor of the oven. (Refer to Fig 16).
5. Slacken the 2 screws securing the burner clamp
bracket at the front of the oven, (Refer to Fig 16), this
will allow the burner to be removed out of the front of
the oven.
6. The main burner injector will now be exposed and can
be unscrewed and removed. (Refer to Fig 17).
7. Remove the main injector and replace with the correct
size injector. (Refer to the ‘Gas Specifications’ table at
the rear of this section).
8. Refit the main burner to the oven and secure the rear
of the burner to floor of the oven with screw. (Refer
to Fig 16).
9. Refit the burner clamp bracket to secure the front of
the burner to the front of the oven. (Refer to Fig 18).
Pilot Injector
1. To remove the oven pilot injector, remove the two
screws securing the pilot burner bracket to the front
of the oven. (Refer to Fig 18).
2. Remove the pilot burner bracket from the front of the
oven (Refer to Fig 19), unscrew and remove the piezo
igniter from the mounting bracket to allow better
access to the pilot supply tube.
3. Unscrew the hex nut holding the pilot supply tube to
the rear of the pilot assembly.
4. Withdraw the pilot injector from the pilot assembly.
5. Replace the pilot injector with the correct sized
injector for the gas type being used and re-connect
the pilot supply tube to the pilot assembly.
6. Refit the piezo igniter to the mounting bracket.
7. Refit the mounting bracket to the front of the oven
and secure to the front of the oven with 2 screws.
(Refer to Fig 18 and 19).
Low Fire (Convection Oven) :
Please note that there is no low fire adjustment
on the gas control valve for the G576 Oven.
Remove screw
Fig 16
Main Burner
Injector
Fig 17
Pilot Supply Line
Thermocouple
Piezo Igniter
Pilot Assembly
Fig 20
Loosen screws and
slide clamp bracket
left to remove burner
Fig 18
Pilot Burner
Bracket Securing
Screws
Fig 19
Pilot Burner Bracket
partly removed
Pilot Supply Line
Thermocouple Piezo Igniter
Pilot Assembly
Pilot Burner
Inspection Covers
Sole Plate
Fig 15