Blue Bird M380 2003, Руководство пользователя

Страница: 37 / 579

M380 Owner’s Manual____________________________________________Safety and Security - Security Features – 1-2
Rev. “F” 1-2-5
1-2.3.20 Remote Starting the Motor Home
IMPORTANT: Only start the motor home in a well ventilated area. Do not use in a closed
garage or indoors. Be sure to familiarize yourself with all features prior to using this product.
To remote start the motor home:
Press the transmitter button 4 for 3 seconds.
•
The parking lights turn on.
•
Approximately 2 seconds later the system will attempt to start the motor home.
•
Once the motor home has started, the heater or air conditioner will turn on and run for the
pre-programmed time (15 or 25 minutes). If the engine fails to start on the first attempt, it will
repeat the starting procedure 2 more times. If the vehicle fails to start after a total of 3 times
the system will shut down.
•
Driving motor home after Remote Starting:
Unlock the door by pressing button 2 on the remote transmitter. Enter motor home, turn ignition key to
the on position.
NOTE: Do not turn the key all the way to the start position as you may damage the starter.
Once the ignition key is turned to the on position, press the brake pedal and shift the motor home into
the proper gear and you may now drive the motor home.
NOTE: If brake pedal is pressed prior to turning on ignition, engine will turn off).
1-2.3.21 Remote Engine Shutdown
If the motor home has been remotely started and you desire to turn the vehicle off, simply press and
hold button 4 on the remote transmitter for three seconds. After the motor has turned off the doors will
relock. This feature must be programmed during installation.
1-2.3.22 Auto Cold Start
This feature allows the system to start and run the motor home every one or two hours (selectable by
the installer) for a period of 24 hours. This allows the engine to remain at an operational temperature
in extremely cold weather. Auto Cold Start must be enabled during installation or it cannot be
engaged.
Engaging the Auto Cold Start feature:
To turn Auto Cold Start on:
1.
Press and hold the brake pedal.
2. While holding the brake pedal down, push the Valet switch and transmitter button 2 for two
seconds.
•
The parking lights will flash four times to indicate the Cold Start feature is engaged.
3. Release the brake pedal.
Disengaging the Auto Cold Start feature:
The Auto Cold Start feature can be deactivated in one of three ways:
•
Press the brake pedal.
•
Turn on the ignition.
•
Remote start the motor home using the transmitter.
1-2.3.24 Stop and Go
The Stop and Go features allows the motor home to remain running without use of the ignition key
during short stops.