Blue Bird M380 2003, Руководство пользователя

Страница: 349 / 579

M380 Owner’s Manual________________Interior and Exterior Systems Operation – Video and Audio Equipment – 4-18
Rev. “G” 4-18-89
4-8.7.5.2 Installing Remote Control
Batteries
To install or replace the remote control
batteries:
1. Locate the battery compartment on the
back of the remote control.
2. Remove the battery compartment cover.
3. Insert two “AAA” size batteries as shown,
observing the correct polarity.
4. Replace the battery compartment cover.
Installing batteries in the remote control
4-8.7.5.3 Programming the Remote Control
You can operate your TV, VCR, and Audio/Video receiver using your HRMC-8 or HMRC-9 remote
control. Use the Code Scanning or Code Entry method to program the remote control. Code scanning
may be more time-consuming, but you don’t need to know manufacturer’s control codes. Using the
Code entry method may be quicker, but you’ll need to know the correct manufacturer’s control codes for
each component you want to operate.
1. Aim your remote control at the component you want to use.
2. Hold down the desired device button (TV, for example).
3. Press the MUTE button for one second.
4. Release both buttons together.
5. The device button (in this example, the TV button) glows and
remains lit. If the button does not light, repeat the previous steps.
6. Use one of the two programming methods described above.
Code Scanning
To use this method:
1. Repeatedly tap the top part of the CHANNEL (CH) button.
2. Continue to step through the codes until the component turns off, indicating you have
found the correct component code. If you accidentally pass a code that responds or
realize you may not have been aiming the remote control at the component, tap the
lower part of the CHANNEL (CH) button to step backward through the codes.
3. Press the remote control POWER button to verify the proper code by turning the
device on and off.
4. Press the device button (in this example, TV) again to lock in the code.
Code Entry
To use this method:
1. Find the three-digit code or codes for the type and brand of the component you want to control (in
this example, TV). Refer to Appendix B of Manufacturers Device Control Codes found later in this
manual.
2. If several codes are not listed, you may have to try some or all of them. After entering a code,
press the remote control’s POWER button to test it. The correct code turns the device on and off.
3. Press the device (DVD, VCR, AUX, TV, SAT) button again to lock the code.