Blue Bird M380 2003, Руководство пользователя

Страница: 182 / 579

4-8 – Interior and Exterior Systems Operation – Awning Operation__________________________M380 Owner’s Manual
4-8-18 Rev. “F”
4-8.4.9.2 Lead Rail Adjustments
Lateral Shifting of Lead Rail
Tools Required:
•
5mm (3/16”) Allen Wrench
•
Phillips Screwdriver
•
Rubber Mallet
•
1/8” Drill Bit and Drill Motor
The Lead Rail has shifted toward the front or toward the rear of the awning casing, preventing the
awning from closing properly.
1. Open the awning about 2 feet.
2. Locate the connection bracket at the forward most portion of the arm at the Lead Rail. (
Item
#43 of Exploded View ). Using an Allen Wrench, loosen the center set screw on this bracket,
by ¾ turn, which un-tightens this bracket from the Lead Rail. Repeat for all arms. Do NOT
loosen the offset leveling screw found on the upper corner of the bracket assembly.
3. With a Phillips Head Screwdriver, remove the (2) fabric set screws ( Item #50 of Exploded
View ) which secure the fabric to the Lead Rail.
4. Close the awning to about 4 inches and, using a rubber mallet, tap on the end of the Lead
Rail, allowing it to shift relative to the fabric and arm attachments.
5. Close the awning to check for proper alignment.
6. Re-open the awning to about 2 feet, and re-tighten set screws at each arm connection. Finish
by replacing both fabric set screws.
NOTE: These screws should be located approx. ¾” from the edge of the fabric. If the
adjustment process places either of these 2 screws further than this point, drill new holes
(1/8” dia) and re-install fabric screws.
7. Close awning completely to check for final fit.
4-8.4.9.3 “IN” Adjustment of Lead Rail
Tools Required:
•
5mm (3/16”) Allen Wrench
•
Rubber Mallet
This adjustment may be required if the Lead Rail remains out from the awning casing at one end. The
Limit Switches may need to be adjusted. Please see that section entitled
ADJUSTING MOTOR LIMIT
SWITCHES . Otherwise, arms may need to be adjusted as follows:
1. Open the awning about 16 inches.
2. At the selected arm, locate the connection bracket at the forward most portion of the arm at
the Lead Rail ( Item #43 of Exploded View ). Using a 5mm (3/16) Allen Wrench, loosen the
center set screw on this bracket, by ¾ turn, which un-tightens this bracket from the Lead Rail.
This bracket should now be free to slide. Do NOT loosen the offset leveling screw found on
the upper corner of this bracket assembly.
3. Close awning completely and the arms will relocate themselves to the proper location. Re-
open the awning just far enough to re-tighten the arm screws.