Blomberg WNF 6200, Руководство пользователя, Страница: 10 / 40

10 - EN
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon in the
softener compartment and pull towards
you until the compartment is removed from
the machine.
C If more than a normal amount of water
and softener mixture starts to gather in the
softener compartment, the siphon must be
cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also
at the end of each water intake hose where
they are connected to the tap. These filters
prevent the foreign substances and dirt in the
water to enter into the machine. Filters should
be cleaned as they get dirty.
• Close the taps.
• Remove the nuts of the water intake hoses
to clean the surfaces of the filters on the
water intake valves with an appropriate
brush.
• If the filters are very dirty, you can pull them
out by means of pliers and clean them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly under
streaming water.
• Replace the gaskets and filters carefully to
their places and tighten the hose nuts by
hand.
case of power failures or when the machine
is unplugged. To deactivate the child-
proof lock, press the 1st and 2nd auxiliary
function buttons for 3 sec.
C
If you turn the program selection knob
when the child-proof lock is activated,
the lights on the auxiliary function buttons
1 and 2 flash for 3 times to indicate that
the child-proof lock is activated. In this
case, any change in temperature, speed
and auxiliary functions which are already
selected for the programs is not allowed.
C
If the program selection knob is turned
to "On/Off" position and then another
program is selected while a program is
running, the previously running program will
resume operating.
Ending the program through
canceling
When another program is selected instead
of a running program by turning the program
selection knob, the previous program is
cancelled. The “End/Cancel” light flashes
continuously to indicate that the program
is cancelled. If conditions to open the door
are met during cancellation (if water level is
suitable, etc.), the "Door" light will flash for
about 1-2 minutes. When the "Door" light
becomes solid after 1 or 2 minutes, it means
that the door can now be opened.
“Stand-By” mode
“Stand-By” mode will allow to save
energy while your machine is not running.
Unnecessary lights and indicators will be
turned off in this mode. Thus, maximum
energy saving is provided.