5
Using the compressor
16
5.2
Control panel
1
OUTLET PRESSURE GAUGE
2
TANK PRESSURE GAUGE
3
PRESSURE REGULATOR
4
COMPRESSED AIR OUTLET
5
STOP/ EMERGENCY
6
START
7
HOURSCOUNTER
8
RESET BUTTON
SINGLE PHASE VER.
THREE-PHASE VER.
5.3
Check the efficiency of the safety devices before starting
OIL LEVEL
Check the oil level as indicated in Section 6
“Compressor maintenance”.
5.4
Starting the
Following an electrical shortage the compressor will start only if the START (I) button is pressed.
Ventilation must occur as illustrated below.
It is of crucial importance that the compressor works with all the panels firmly closed.
The failed observance of these and the following standards may lead to accidents that could
cause personal injury and serious damages to the compressor or its equipment.
Before initially starting the compressor or following extended inoperative periods, start the machine intermittently by
pressing the START(I)-STOP(O) buttons on and off for 3 or 4 seconds. After this it is advisable to run the compressor
for a few minutes with the air outlet tap open.
Then gradually shut-off the air tap and load to maximum pressure, checking if the inputs on each phase of the power
supply are within the limits and also if the pressure switch trips.
At this stage, when the max pressure value is arrived, the pressure switch start the idle running for 2 minutes; after this
time,
if there’s not air consumption, the compressor stop in stand-by condition. Discharge the air from the tank until the
starting pressure is reached (2 bar difference compared to maximum pressure ). Shut-off the air outlet tap and wait for
the pressure switch to trip, which will shut-on the in-take valve and close the internal discharge.
CALIBRATION AND SETTINGS MADE BY THE MANUFACTURER
MODEL
SETTING
9
bar
7÷9
bar
7,5 bar
5,5÷7,5 bar
PROTEZIONE TEMPERATURA OLIO
OIL TEM PERATURE PROTECTION
1
2
3
4
5
6
7
8
PROTEZIONE TEMPERATURA OLIO
OIL TEM PERATURE PROTECTION
5
6
Содержание MONSUN Fast R
Страница 1: ...Operating instructions MONSUN Fast R Screw Compressors Type Serial number Date 121455 01 2015 ...
Страница 29: ...7 Drowing and diagrams 28 7 2 Pneumatic diagrams ...
Страница 30: ...Drowing and diagrams 7 29 Maintenance program Model Serial Date Intervention Hours of duty Operator sign ...
Страница 31: ...7 Drowings and diagrams 30 Maintenance program Model Serial Date Intervention Hours of duty Operator sign ...