Air Pressure setting
recommendAtion
(Diaphragm Compressor Models) for
Sustained High Altitude Operations.
requirements
test Procedure
a)
Basic Hand Tools.
b)
Proheat Remote Start Switch (P/N PK0091).
c)
Proheat Digital Manometer Test Gauge (P/N PK0036).
d)
Or Proheat Analog Air Pressure Test Gauge (P/N PK0067).
Sustained operation and servicing of the M-Series compressor above
4,000 ft (1219 m) requires the compressor setting be checked and/or
adjusted for proper combustion.
a)
Disconnect all harnesses at the PCM.
b
) Disconnect the fuel supply line.
c)
Loosen and back out the burner head mounting (2) bolts five to
six turns allowing enough room to rotate the burner head 15°
counter-clockwise and remove.
HOUSING SCREWS
TORQUE = 75 IN-LBS
AIR FILTER
POWER
SWITCH INPUT
FUEL INLET
TEMP SENSOR
MOUNTING BOLTS (2)
TORQUE = 100 IN-LBS
Figure A. Burner Head & Blower Housing Removal.
Shock hazard due to high secondary
coil voltage.
WARNING
Copy Part# SB0063, Rev. A, 08/2014
Page 1 of 4
© 2011 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6
Tel: 604.270.6899
Web: www.proheat.com
SERVICE BULLETIN
Before adjusting air pressure, ensure
the Air Compressor filter and Fuel
Nozzle are clean. See service manual
at: www.proheat.com
NOTICE
To avoid the risk of shock and to
ensure that the PROHEAT does not
start, disconnect the Ignition
Module and Fuel Solenoid harness’s
at the PCM.
WARNING
