75
If the radio connection is protected
by a 10-A fuse:
CAUTION!
Risk of damage to the
device!
If you connect vehicle connectors
directly to the device, it may dam-
age the device. This also applies to
pre-fabricated ISO connectors.
Use only vehicle-specifi c adapter
cables from Blaupunkt.
Connect the vehicle-specific
adapter cable
1
to the vehicle
connector
2
and to chamber
A
5
on the rear side of the de-
vice.
If the radio connection is
not
pro-
tected by a 10-A fuse:
Connect the negative wire to the
negative pole of the battery.
Connect the positive wire to the
positive pole of the battery via
a 10-A fl oating fuse so that the
10-A fl oating fuse is at a maxi-
mum distance of 30 cm from the
positive pole of the battery.
➜
➜
➜
➜
Do not lay the wires parallel to
wire harnesses.
Connecting the loudspeakers
If passively pre-equipped with
4-ohm loudspeakers:
Adapt the ISO connector
7
of
the vehicle to the plug assign-
ment shown in the illustration
below.
If required, connect an ISO
extension cable (order no.
7 607 647 093).
Plug the connector into cham-
ber B
6
of the device.
If actively pre-equipped (separate
output stages):
Connect the special adapter ca-
bles to chamber C1 according
to the manufacturer's instruc-
tions.
Connecting the radio antenna
With pre-equipped vehicles, such as
VW, Seat or Audi, the supply voltage
for the antenna is supplied via the
antenna cable (see the operating
instructions of the vehicle). If the
original equipment radio of such a
vehicle is to be replaced by a com-
mercial radio, you must obtain an
antenna feed separating fi lter (or-
der no. 7 691 290 202) or the adapt-
➜
➜
➜
➜
➜
A
1
2
3
5
4
RR R
F LF
LR
4 Ohm
4 Ohm
4 Ohm
4 Ohm
+
-
+
-
+
-
+
-
A
6
7
Installation instructions
ROME56E_eng.indd 75
ROME56E_eng.indd 75
23.08.2006 15:05:20 Uhr
23.08.2006 15:05:20 Uhr
