Blata Minibike Elite 14 WRS, Руководство по обслуживанию

Страница: 6 / 24

UNPACKING AND SETTING UP BEFORE RIDING
The minibike is delivered in a cardboard carton and packed with folded
handlebars and brake levers. After unpacking, set up the handlebars into the
position, that suits the best for driving. The maximum pulled brake lever
position should not touch on the handlebar grip. After setting up, tighten the
handlebar bolts 1, brake lever bolts 2, and the throttle assy. Bolts. See, Fig. 1.
The level of foot rest’s can be regulated by loosening the bolt M5 (914.003.01)
on the handle of the foot rest (139.001.01). The foot rest can be moved to the
front or back position. It is recommended to try and check the position of
handlebars and foot rest’s individually. While tightening the bolts and nuts, do
not use an excessive force as to not damage the threads, or distort the tubes
and other parts. Verify the smooth and perfect function of the Bowden cables
to throttle and both brakes. Fill the cooling system with coolant and vent the
system (follow the instructions in chapter MAINTENANCE OF COOLING
SYSTEM). Fill the fuel tank with fuel mixture. Failure to use the proper oil mix
ratio will result in Engine damage for which you will be responsible.
FIG. 1
Operating
controls:
1. Handlebar bolts
2. Brake lever bolts
3. Throttle Assy. bolts
4. Stop switch
5. Front brake lever
6. Rear brake lever
7. Balance tank for coolant
Range of adjusting handlebars
function position
SAFETY
The minibike is unsuitable for public road use. It does not comply with valid
Safety Standards. Unsafe and careless use of a minibike can result in serious
injuries. The driver can minimize the potential risks by wearing the Safety
Equipment. The driver must wear safety helmet, goggles, gloves, elbow pads,
kneepads, and firm footwear. The minibike cannot be used on wet, icy or oily
surfaces. Avoid uneven surfaces and obstacles. Drive with two hands on the
handlebars.
BEFORE STARTING
It is strongly recommended to follow all the instructions about the break-in
period to promote engine reliability and long life. Break-in period of the
minibike is complete after the consumption of five full fuel tanks. It is important
to use mixture of petrol 95 or higher Octane with 2-stroke synthetic oil in the
ratio 30:1 and after break-in period a ratio of 33:1. Mix the petrol and oil
completely before putting it into the fuel tank. During the break-in period do
not run the engine at maximum RPM and do not allow the engine to overheat.
3
1
1
2
3
4
6 5
7