22
Starting up the machine (GHY version)
Turn on the dust collector
Check if the treadle (pos. 1 page 19) of the drive system is down, and the driving lever (pos. 6 page
19) is in the neutral position.
Turn the earth switch into a vertical position (pos. E page 19). See photos 2.1.
Turn the starting key to position "0", every time you want to start the engine. (See photo1 page 19.).
Check the speed control lever (pos. 11, page 19), first move the control lever to the stop position.
(see photo 2)
Photo 2.
Photo 2.1
Depending on the situation, place the speed control lever in either the "½" or "start"position.( see
photo 3 and 4).
Photo 3. "½" position
Photo 4. "start" position.
Insert the starting key all the way and turn to position (I). (see photo1 page 18)
Turn the key to position (II). (see photo1 page 19). As soon as the engine is running, release the
starting key. The starting key springs back into position "I" and remains in this position during
operation.
Lock the fine adjustment so the depth cannot change during sawing. This must be done with the
machine in the lower position (quick lift lever in lower position)
Slowly let down the quick lift lever.
Turn the fine adjustment clockwise until the desired sawing depth is reached.
Lock the fine adjustment so the depth cannot change during sawing.
Set the drive speed with the driving lever (pos. 6 page 19). This must be done once the machine is on
the floor.
