18
1.
Treadle of drive system
It is possible to transport the machine without the use of the motor by pushing up the treadle (1). The
drive wheels are declutched of the drive motors now. In the downward position the wheels are
engaged to the drive motors. Make sure that the floor is flat, because the machine is uncontrolled now!
It is very dangerous to drive the machine on a grade or ramp when the treadle is in upwards
position!
2.
Dust hose connection
The dust hose to the dust collector must be connected here. Use hose clamps and industrial tape for a
reliable connection.
3.
Quick lift lever
In the upright position the drum is lifted off of the ground, in the downwards position, the drum is put
on the ground. The quick lift lever enables the operator to lift the complete drum without changing the
fine adjustment of the working depth. The lever must be in the upright position before start-up, in
order to prevent a run out of the motor under full load.
4.
Fine adjustment
The working depth can be adjusted by turning the fine adjustment wheel. The sawing depth must be
adjusted considering the surface to be treated. The progressively depth adjustment enables the sawing
blades to saw into the surface being treated only at the required and necessary depth. When the depth
adjustment is correctly selected, the machine will run quiet and constant.
6.
Dead man’s switch
The key of the dead man’s switch is attached to a cord. The cord should be fastened on the arm of the
operator. When the key is pulled out, the machine will stop immediately.
7.
Driving lever
The drive unit control lever is used to control the machine’s drive unit. The function of the drive unit
control lever begins after adjusting the working depth of the machine with the quick lift. You should
pay attention that the drive unit control lever is locked in the neutral position before manipulating the
quick lift.
10.
“Sawing - scarify motor” ON/OFF buttons
Pressing the green start button will start the sawing - scarify motor. Before starting the sawing -
scarify motor, the treadle of the drive system must be in de downwards position and the quick lift lever
must be in the upwards position.
11.
Control light “Phase incorrect”
This lamp shines when the phases of the power supply are incorrect. The power plug has a built in
phase inverter for easy and quick changing of the phases if the control light “Phase incorrect” lights up.
12.
Hydraulic pump motor ON/OFF buttons
Pressing the green start button will start the driving motor, use the driving lever to start driving. The
hydraulic motor hast to be switched on before switching on the sawing motor. The red button will stop
the hydraulic motor.
13.
Emergency shutdown button
Red mushroom-shaped shutdown push button, this button cuts off the power to the motors.
Turn to unlock the emergency stop button.
14.
Hour counter
Shows the number of working hours. Useful for maintaining a proper maintenance schedule.
15.
Amp meter
This meter shows the power consumption of the saw / scarify motor in ampere.
16.
Plug for power supply
The plug for the power supply has a built in phase inverter.
If the motor turns the wrong way, just unplug the machine and change the phase inside the plug.
