6
3. Safety
Warning!
Read all safety warnings and all instructions.
Failure to follow the warnings and
instructions may result in electric shock, fire, explosions and / or serious injuries.
Only authorized and trained personnel may operate this machine. This machine is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge.
It is the responsibility of the user to analyse the surface to be treated. The surface may not contain any
substances which could pose a fire-, explosion- or health risk when treated. The user should make a risk
assessment on the basis of the information obtained about the surface to be treated and take proper
precautions for the work to be performed.
In case of any inappropriate usage, improper operation or repair, the producer shall be exempt from liability.
3.1
Work area safety
a)
Do not use the machine in rain, damp or wet locations.
b)
Avoid dangerous environments: do not work in the presence of explosive atmospheres, in the presence of
flammable liquids, gases or dust. Remove materials or debris that may be ignited by sparks.
c)
In some cases sparks could be created by
sawing, scarifying or milling.
d)
The surface to be treated must be clean, make sure to remove all stones, screws etc..
e)
Do not use on wood.
f)
Make sure there is enough ambient light on the work area. Cluttered or dark areas invite accidents.
g)
Keep children and bystanders away while operating the machine. They are likely not to foresee the
potential dangers of the machine. Distractions could cause you to lose control of the machine.
h)
Persons who are not operating the machine must not be permitted to stay in the surrounding area of at
least 5 meter from the machine.
i)
Never use the machine when the surface is not clear and if there is a risk of stumbling or tripping.
j)
Remove electrical cables and dust hose(s) from the surface to be treated.
k)
Make sure that there are no cables or hoses in the driving direction of the machine.
l)
Make sure that there is nothing standing or situated on the surface to be treated.
m)
Make sure the machine can travel over all inequalities on the surface, small inequalities like weld seams or
(floor) joints are no barriers for the machine.
n)
Never stay in the rain with the machine.
o)
Check if there are any obstacles that can snag the cables when the machine is moving.
p)
Remove all objects from the surface that can damage the machine. Remove reinforcing steel or other
objects protruding from the surface in order to prevent damage to the machine.
q)
Warning! Make sure that the surface to be treated does not contain dangerous materials such
as:
- combustible or explosive dusts or substances.
- carcinogenic or pathogenic substances.
r)
It is necessary to provide for an adequate air change rate L in the room if the exhaust air from the dust
collector is returned to the room. Comply with the National regulations.
s)
Secure the work area around the machine in public areas providing an adequate safety distance from the
machine. Use a red and white safety chain and danger sign to enclose the work area.
t)
Danger to life from inhaling exhaust gases. Toxic engine exhaust gases can lead to loss of consciousness
and even death in closed-off and poorly ventilated rooms.
▪ Never operate the machine in closed-off or poorly ventilated rooms.
▪ Do not breathe in the exhaust gases.
u)
Only work on locations which are adequately ventilated.
3.2 Personal safety
a)
Always wear Personal Protective Equipment while working with the machine.
-Dust mask class FFP3 or higher
-Ear protection
-Safety glasses with lateral protection
-Protecting gloves
-Safety shoes
