Blackmagicdesign teranex mini, Инструкция по установке и эксплуатации

Страница: 79 / 657

Analog Audio Channels Switch 6 Switch 5 Switch 4 Switch Diagram
9-10 ON OFF OFF
11-12 ON OFF ON
13-14 ON ON OFF
15-16 ON ON ON
AES/EBU Audio Channels Switch 6 Switch 5 Switch 4 Switch Diagram
1-4 OFF OFF OFF
5-8 OFF OFF ON
9-12 OFF ON OFF
13-16 OFF ON ON
Blackmagic Teranex Setup Settings
The Teranex setup utility can change all the same settings that are available using the switches,
plus additional settings.You can access these settings by moving between the ‘audio,’
‘configure,’ and ‘about’ tabs in Blackmagic Teranex Setup. The ‘about’ and ‘configure’ tabs are
detailed in the ‘Changing settings’ section in this manual.
The ‘audio’ tab for Teranex Mini Audio to Optical 12G contains the following settings.
Audio Input Menu
This menu allows you to select between RCA, XLR, and optical inputs.
If you have selected XLR, you can further select between analog, AES/EBU, and
timecode inputs.
Selecting AES/EBU allows the additional option of checking ‘sample rate conversion.’ When this
is selected, the sample rate of your optical audio output will be forced to 48kHz, the correct
sample rate for television.
The audio input menu also allows you to chose which channel pair, or channel quad in the case
of AES/EBU audio, of your SDI or optical signal you wish to embed audio into, as well as
adjusting the audio gain.
You can bypass channels or channel pairs if you want to avoid overwriting audio in your
SDI or optical signal.
Your Teranex Mini will retain its last settings whether applied via switch, Smart Panel or
Blackmagic Teranex Setup. If reverting to switch control after removing the Smart Panel or
updating your converter’s settings via software, you may need to toggle individual switches for
new settings to take effect.
79 79 Teranex Mini - Audio to Optical 12G