6
www.digiop.com
SECTION 2: INSTALLATION AND SETUP
7.
If the lens assembly has an Auto Iris feature, attach the lens cable to the 4-pin connector on the back of the camera. Pin
definitions are shown in the table below.
8.
Attach the camera to the mounting bracket. Use the instructions provided with the bracket.
9.
Remove the protective cap from the end of the camera lens, if one is attached.
2.4 Connections
Connections to the camera for audio in and out (microphone and speaker), D/I sensor, alarm, and RS-485 control are made through
the 9-pin terminal block.
9-pin terminal block
Terminal block pin assignments
If the 9-pin terminal block is detached from the camera, plug it into the mating connector on the back of the camera.