20
SECTION 3: SOFTWARE SETUP
VALUE
(sensitivity):
VALUE allows you to select the camera sensitivity to movement in the area selected. The higher the
setting value is, the higher the sensitivity to movement.
MOTION VIEW
: This feature is used to highlight objects found moving in motion detection areas.
—
OFF
. The feature is not used.
—
ON
: When motion is detected, the motion detection areas where motion is detected are highlighted.
RETURN
: Select RETURN to return to the SPECIAL menu.
PRIVACY
: The PRIVACY feature allows you to block up to 8 areas of the image from being seen. The areas blocked are covered by
a color-coded polygonal (3-, 4-, or 5-sided) shape. Set PRIVACY to ON then press the joystick in to open the PRIVACY sub-menu.
AREA
: Set the cursor on AREA, then rock the joystick right or left to select any area 1 .. 8. These 8 areas can be individually
enabled or disabled, positioned anywhere over image, are color coded, and can be reshaped. To setup a privacy for the area
selected:
—
Set the cursor on AREA DISPLAY and rock the cursor to ON to use the area, or OFF to disable it. If set to ON, press the
joystick in to re-shape and position the privacy area:
—
To reshape the privacy area, rock the joystick up, down, left or right to reposition the corner of the shape you
want to move. Press the joystick in to move to another corner of the image, then advance to the POSITION
display. You can reposition the top left, top right, bottom left, and bottom right corners of the shape.
—
In the POSITION display, rock the joystick up, down, left or right to move the shape to the area you want to block,
then press the joystick in to select it.
—
If using the area, move the cursor to COLOR, and rock the joystick left or right to select one of 15 colors for the
rectangle.
—
Repeat this procedure for each of the 8 areas.
RETURN
: Select RETURN to return to the SPECIAL menu.
DEFECT
: This feature is used to eliminate up to 512 white spots (defects) in the image. Selecting DEFECT opens the DEFECT
sub-menu.
