6
SECTION 2: INSTALLATION
3.
Verify that video from the camera can be seen on the monitor.
4.
While observing video from the camera, loosen the direction adjustment lock nut and the elevation and horizon adjust hex
screws (use the hex wrench provided).
5.
Point the camera at your surveillance target, then tighten the lock nut and hex screws to hold the camera in place.
Far-Near, Tele-Wide controls
Direction adjustment
lock nut
Horizon adjustment
Elevation adjustment
OSD Control
360°
180°
360°
6.
Rotate the
Far - Near
adjustment ring and the
Tele - Wide
adjustment ring to improve the image of the your
surveillance target.
7.
Configure your camera using the software menus in the OSD. See
Software Setup
in the following section of this
manual.
2.3.1 LED LEVEL adjustment (BLK-CPB700R150, BLK-CPB700R300 only)
The LED LEVEL is preset at the factory. However, an adjustment screw is provided on the OSD panel of the BLK-CPB700R150 and
BLK-CPB700R300 cameras for environments where the image brightness in dark conditions is still not satisfactory after performing
a Software Setup of the camera. The LED LEVEL of the BLK-CPB700R65 camera is not adjustable.
