BK Precision 4060B Series, Руководство по программированию

Страница: 8 / 28

Common Command Introduction 8
failures are identified by a unique binary code in the returned <status> number. A “0” response
indicates that no failures occurred.
Query Format *TST?
Query Response *TST <status>
<status> = 0 self-test successful
Example The following causes a self-test to be performed:
TST?
Return(if no failure):
*TST 0
Related Commands *CAL
2.10 WAI
Description The *WAI (WAIT to continue) command, requires by the IEEE 488.2 standard, has no effect on
the instrument, as the signal generator only starts processing a command when the previous com-
mand has been entirely executed.
Command Syntax *WAI
Related Commands *OPC
2.11 Comm_Header Command
Description This command is used to change the query command returned format. “SHORT” parameter re-
turns short format. “LONG” parameter returns long format. “OFF” returns nothing.
Command Syntax Comm_HeaDeR <parameter>
<parameter>={SHORT,LONG,OFF}
Query Format Comm_HeaDeR?
Query Response chdr <parameter>
Example Set query command format to long. CHDR LONG Read query command format.
CHDR?
Return:
COMM_HEADER LONG
2.12 Output Command
Description Enable or disable the output of the [Output] connector at the front panel corresponding to the
channel. The query returns “ON” or “OFF” and “LOAD”, “PLRT” parameters.
Command Syntax <channel>:OUTPut <parameter>
<channel>={C1, C2}
<parameter >={a parameter from the table below}
< load>={please see the note below.}
Parameters Value Description
ON — Turn on
OFF — Turn off
LOAD <load> value of load(defaultunite is ohm)
PLRT <NOR,INVT> value of polarity parameter