BK Precision 4060B Series, Руководство по программированию

Страница: 12 / 28

Common Command Introduction 12
Parameters Value Description
PM, MDSP <mod wave shape> PM modulation wave. Only when PM signal source
is set to INT, you can set the parameter.
PM, FRQ <PM frequency> PM frequency. Only when PM signal source is set to
INT, you can set the parameter.
PWM, FRQ <PWM frequency> PWM frequency. Only when carrier wave is PULSE
wave, you can set the parameter.
PWM, DEVI <PWM dev> Duty cycle deviation. Only when carrier wave is
PULSE wave, you can set the parameter.
PWM, MDSP <mod wave shape> PWM modulation wave. Only when carrier wave is
PULSE wave, you can set the parameter.
PWM, SRC <src> PWM signal source.
PM, DEVI <PM phase offset> PM phase deviation. Only when PM signal source is
set to INT, you can set the parameter.
ASK, SRC <src> ASK signal source.
ASK, KFRQ <ASK key frequency> ASK key frequency. Only when ASK signal source is
set to INT, you can set the parameter.
FSK, KFRQ <FSK key frequency> FSK key frequency. Only when FSK signal source is
set to INT, you can set the parameter.
FSK, HFRQ <FSK hop frequency> FSK hop frequency.
FSK, SRC
<src> FSK signal source.
PSK, KFRQ <FSK key frequency> PSK key frequency. Only when PSK signal source is
set to INT, you can set the parameter.
PSK, SRC <src> PSK signal source.
CARR, WVTP <wave type> Carrier wave type.
CARR, FRQ <frequency> Value of carrier frequency.
CARR, AMP <amplitude> Value of carrier amplitude.
CARR, OFST <offset> Value of carrier offset.
CARR, SYM <symmetry> Value of carrier symmetry. Only ramp can set this
parameter.
CARR, DUTY <duty> Value of duty cycle. Only square and pulse can set
this parameter.
CARR, PHSE <phase> Value of carrier phase.
CARR, RISE <rise> Value of rise time. Only Pulse can set this
parameter.
CARR, FALL <fall> Value of fall time. Only Pulse can set this parameter.
CARR,DLY <DELAY> Value of carrier delay.Only PULSE can set this
parameter.
Note: If carrier wave is Noise you can’t set to turn on modulation.
If you want to set AM, FM, PM, CARR and STATE the first parameter have to be one of them.
where: <state>={ON, OFF}
<src>={INT, EXT}
<mod wave shape>={SINE, SQUARE, TRIANGLE, UP RAMP, DNRAMP, NOISE, ARB}
<am frequency>={Default unit is "Hz". Value depends on the model.} <depth>={0% to 120%}
<fm frequency>={Default unit is "Hz". Value depends on the model.} <fm frequency devia-
tion > ={0 to carrier frequency, Value depends on the difference between carrier frequency and
bandwidth frequency.} <pm frequency> ={Default unit is "Hz", Value depends on the model.}
<pm phase deviation >={0 to 360.} <pwm frequency>={Default unit is "Hz", Value depends
on the model.}