M
O
WAY
Title
: mOway Beginner Manual
Rev
: v2.1.3 – March 2011
Page
59
of
65
www.moway-robot.com
You can access the application in Window/Radio Control or using the button
shown in the next image.
Image 79. Access from mOwayGUI
6.1.
Description of the mOway RC Center
The different parts of the program are described below.
6.1.1.
RF configuration
In this part the RFUsb module is configured with a 0x02 default address and 0x00
for the communications channel (default mOway RC program channel). The Radio
Control’s indicator (dispatch status) on the left lower part will glow red when
configuring the module with the robot switched off.
Once connected, the communications channel can be changed if WI-FI, Bluetooth,
Microwaves, etc. interferences are detected in this first channel. Click on the change
channel button to select up to 16 channels. To change the channel the robot has to be
switched on and be in communication with the RFUsb.
Every time the RFUsb is disconnected the default channel shall be 0x00.
The recommended procedure is as follows:
1) Turn the robot on
2) Connect the
RFUsb
3) Test the channel sending mOway commands
4) If the robot does not react well change the channel and try again
