BT-720 Operation manual
P/N:720-ENG-OPM-ENG-R03
Bistos Co., Ltd.
2020.10
8
components and do not spray cleaning solutions onto any of these surfaces. Personal
injury or equipment damage could occur.
Do not expose the unit to excessive moisture that would allow for liquid pooling.
Personal injury or equipment damage could occur.
Do not touch the patient and signal input/output parts simultaneously
Due to the risk of electrical shock hazard, only qualified personnel with appropriate
service documentation should service the monitor.
0.3 Battery warnings
WARNING
Improper operation may cause the internal lithium ion battery to be hot, ignited or
exploded, and it may lead to the decrease of the battery capacity. It is necessary to read
the operation manual carefully and pay more attention to warning message.
Do not open the battery compartment. Only the qualified service personnel authorized
by the manufacturer can open the battery compartment and replace the battery, and
batteries of same model and specification should be replaced.
Be careful when connecting the battery with polarity.
Do not use the battery near fire or environmental temperature exceeds 60
℃
. Do not
heat or splash the battery or throw it into fire or water.
Do not destroy the battery. Do not pierce battery with a sharp object such as a needle.
Do not hit with a hammer, step on or throw or drop the battery. Do not disassemble or
modify the battery. The battery can heat, smoke, deformation or burning.
When leakage or foul smell is found, stop using the battery immediately. If your skin or
cloth comes into contact with leaked liquid, cleanse it with clean water at once. If the
leaked liquid splashes into your eyes, do not wipe them. Irrigate them with clean water
first and go to see a doctor immediately.
Properly dispose of or recycle the depleted battery according to local regulations.
0.4 General precautions on environment
Do not keep or operate the equipment under the environment listed below.
Avoid placing in an area exposed
to moisture. Do not touch the
equipment with wet hand.
Avoid exposure to direct
sunlight
Avoid placing in an area where
high variation of temperature
exists. Operating temperature
ranges from 5
℃
~ 40
℃
.
Operating humidity ranges from
30 % ~ 85 %.
Avoid in the vicinity of
electric heater.
Avoid placing in an area where
there is an excessive humidity
rise or ventilation problem.
Avoid placing in an area
where there is an excessive
shock or vibration.
Avoid placing in an area where
chemicals are stored or where
there is in danger of gas leakage.
Avoid dust and especially
metal material enter into
the equipment
Do not disjoint or disassemble
the device. Bistos Co., Ltd. does
not have liability of it.
Power off when the
equipment is not fully
ready to operate.
Otherwise, the equipment
could be damaged.