INSTALLATION, OPERATION AND MAINTENANCE MANUAL
BiSolid Saver OM-BSSV00/08/2012/EN
37
Warning
Connecting a room thermostat: Before connecting the room thermostat to the
connector (moving part) for ROOM THERMOSTAT (positioned on the back of
the boiler’s side cover panel), remove the factory installed bridge, located in the
connector. Use only room thermostat contact without external voltage! Please
see the wiring diagram!
Bushing installation, respectively water temperature sensor Pt1000 must be performed
according to the scheme presented in Figure 16.
Figure 16. Installation of water temperature sensor
Warning
Installation of the temperature sensor must be performed as shown on the
above presented scheme. This is operation related to people’s safety and must
be performed by qualified technical personal!
1. Direction for
removing cover panel
2. Direction for
removing cover panel
3. Direction for
removing cover panel
4. Position for
installation of sensor
Pt1000
5. Direction for
installation of cover
panel
6. Direction for
installation of cover
panel
7. Direction for
installation of cover
panel