For best results, use knife and plate as a set.
Do not operate machine for any period of time
without product in the grinding bowl. This will cause heating and dulling of the knife and plate.
5
13. If machine runs clockwise(backwards), it must be rewired to correct rotation, otherwise serious
irreparable damage may occur to the grinding components. Both the auger and the mixing paddle must
operate in the proper direction.
14. Check operation of optional footswitch if equipped. Plug footswitch cord into fitting at the bottom of
the pushbutton control box. Move toggle selector to foot. The machine will operate with pressure on the
footswitch treadle. Releasing the treadle stops the machine. The footswitch operates the mix and grind
together.
15. Insert auger assembly into the grinding bowl and fully engage the auger into the drive shaft. Place knife
(sharp edges out) then grinding plate into end of grinding bowl. The grinding plate slides over the
knife drive pin, and is held from rotating during operation by three pins in the grinding bowl. Install the
end retaining ring.
ONLY HAND TIGHTEN RETAINING RING
16. Check placement of all warning labels and Manual. Machine is now ready for trained operators to process
product.
17. Use meat deflector attached to grinding bowl to eliminate meat splatter.
18. Contact your local Distributor or BIRO directly if you have any questions or problems with the installation
or operation of this machine.
10. Two sets of green and red pushbuttons are located on the front of the machine that activate the magnetic
contactors that control the mix and grind motors. The magnetic interlock switch is mounted in the
pushbutton box. It lines up with the magnet attached to the product mixer safety cover. When the safety
cover is raised the machine will stop operation.
12. Push the green start button for mix.
CHECK THE ROTATION OF THE MIXING PADDLE;
ROTATION MUST BE COUNTER-CLOCKWISE
as indicated by the rotation decal affixed to the
mixer paddle front mounting hub. Backwards operation will not allow mixing paddle to feed product to
the grinding auger efficiently.
11. Push the green start button for grind.
CHECK THE ROTATION OF THE AUGER DRIVE SHAFT;
ROTATION MUST BE COUNTER-CLOCKWISE
as indicated by the rotation decal located on the
grinding bowl.
ROTATION MUST ONLY BE CHECKED WITH THE GRINDING AUGER
REMOVED,
otherwise serious irreparable damage may occur to grinding components.
Содержание AFMG-52
Страница 16: ...14 OPTIONAL EAGLE BELT DRIVE SYSTEM ...
Страница 28: ...26 TANDEM OPERATION ILLUSTRATION FOR 35 INLET ...
Страница 29: ...27 WIRING DIAGRAM ...