BIRO AFMG-52, Руководство по эксплуатации и обслуживанию

Страница: 9 / 32

7
CLEANING
• ALWAYS
Turn Off, Unplug Machine From Power Source and Perform Lockout/Tagout
Procedures to this Machine BEFORE Cleaning or Servicing.
• ONLY Use Recommended Cleaning Equipment, Materials, and Procedures.
• NEVER Spray Water or Other Liquid Substances Directly at Motor, Power Switch or any Other
Electrical Components.
• ALWAYS Thoroughly Clean Equipment at Least Daily.
CLEANING THE BIRO MIXER-GRINDER
l. Disconnect mixer grinder from power-source and perform lockout/tagout procedures.
3. Remove mixing paddle. Be sure front most paddle arm is pointing up. Loosen the thumb screw on the mix-
er paddle lock arm (Item No. 53852). While supporting the mixing paddle, remove the lock arm. Turn the
mixing paddle clockwise, slide forward to disengage the drive shaft and lift from product hopper.
DO NOT POWER SPRAY DIRECTLY AT ELECTRICAL COMPONENTS
6. After machine has been cleaned and allowed to air dry, all exposed metal surfaces should be coated with a
good food grade light oil or grease.
1. Do not use abrasive cleaning materials, such as brillo pads or metal scrapers. Tin is a soft metal and should
be cleaned with a soft cloth and dried.
2. Do not use a cleaning agent containing a high percentage of free alkali or acid.
3. Do not use a detergent containing a high percentage of tri-sodium phosphate or meta-silicate.
Tin is reactive to both.
4. Rinse well and dry thoroughly after washing to remove agents that may be reactive to tin.
5. If sterilizing agent containing chlorine is used, the tinned surface must be thoroughly rinsed.
Chlorine is corrosive to tin.
6. Dry thoroughly after rinsing and store in a dry environment.
7. If water is exceptionally hard, drying will be necessary to prevent spotting.
ROTATING GRINDING AUGER & ROTATING MIXING PADDLE
TO AVOID SERIOUS PERSONAL INJURY
CLEANING THE BOWL- RING AND WORM
CARE OF TIN COATED PRODUCTS
(DO’S AND DON’TS)
5. The grinding head can be removed for cleaning if desired. This is accomplished by removing the three nuts
on the back flange of the grinding head.
4. Machine is now ready to be cleaned using warm soapy water and rinsed with clean water. Clean all
removed parts, grinding bowl end ring, breaker plate, knife, grinding auger, mixing paddle and mixer
paddle lock arm. Machine may be cleaned by power spray washing, taking care not to spray directly at any
electrical controls. Do not spray directly at switches, motors or electrical enclosure.
2. Remove grinding bowl end ring, breaker plate, knife and grinding auger. Care is needed when handling the
knife. Take care when handling the knife during cleaning.