Note on test input:
Testing is only possible for:
– stationary mode
– DC supply Power
Attention: diagrammed currentless!
Function of test input:
When the test input is active (voltage
present), the sensor is switched off.
This simulates a detection and when
functioning correctly causes the
relay to switch.
Set the scanning range between
250 mm (9.84") and 800 mm (31.5")
above the background / floor.
Adjust the scanning range with
the adjustment wheel.
Connect the cables to the terminal
in acc. with the diagram
2.4
Electrical connection
The terminal block can be pushed out from
below with a screwdriver if necessary
2.7
Scanning range
Increasing the
scanning range
Increasing the
scanning range
Decreasing the
scanning range
2.9
Inclination angle
0 to 30°
2000 mm (6.56')
1150 mm (3.77')
Scale
30°
0°
2.8
Adjust detection area
Adjust the detection area by
sliding the sensor (red mounting
brackets should be open for
easy adjustements).
Decreasing the
scanning range
2.5
Mounting the sensor
Before the mounting brackets are clicked-in the red screw must be released.
Mount the sensor in the housing and slide both mounting
brackets up to the sensor.
Note:
The cable
behind
the mounting bracket.
Make sure the red screws on the mounting
brackets are fully open before inserting the
sensor into the brackets.
2.6
Checking the settings
Power on the sensor after all installa-
tions have been completed
Check the detection range with a piece
of paper (A4 or Letter 8.5" x 11") or the
palm of your hand.
If necessary, adapt the detection char-
acteristics as described in chapter 2.7,
2.8 and 2.9.
Note:
The LED lights up when the
sensor detects a presence.
2
3
4
5
6
+
⁄
~
commun
nc
no
Entrée de test
Plug the plug-in screw terminal back
in again and route the cable away
over the guide bridge.
Set the inclination angle with the aid of the
detents on the mounting bracket.
Note:
Take care, to have the same angle
adjusted on both side (readable on
the scale). Otherwise the sensor
sits inclined in the profile.
Background / Floor
Background / Floor
800 mm
250 mm
6
