GETTING YOU STARTED
2
INSTRUCTION BOOK
PREPARATION
o
Watch the videos on how to install on our website (
).
http://www.bionizer.com.au/instructions-videos/
o
If your pool has algae then super-chlorinate as per page 30 of the Bionizer manual before proceeding.
o
Test pool water and bring into balance using the Snap Pool Balance Chart as your guide.
o
For new pools or pools that have just been refilled: Add 1x15kg bag of salt per 50,000 litres to help water conductivity
– brush in well to dissolve. This allows your Bionizer to operate on full power when boost function is activated.
o
refer to page 8 of the Bionizer Instructions.
IMPORTANT: NEW POOLS OR NEWLY RENOVATED POOLS
o
Check filter medium – we recommend changing your filter medium if it is more than 5 years old (Bionizer's
recommendation: glass or silica sand for filter). Make sure your cartridge is in good condition if you have a cartridge
filter.
START-UP
o
Locate the Copper Start-up Kit in your Bionizer packaging. Measure half a lid (40 grams) and pour into the skimmer box
for every 30,000 litres of pool water (make sure the filter is running).
o
After 30 minutes of filtering: test the water for copper level using the copper test kit.
o
Plug your pool pump into the Bionizer and plug Bionizer Control unit into power.
o
Enter real time of day as per page 13.
o
Enter pool size (volume) as per page 13.
o
Enter desired pumping times (4 pumping sessions available) as per page 14.
o
Ensure that the Bionizer is switched to
setting. See page 15.
AUTO
o
Activate the boost function on Bionizer. Enter the copper level you measured and start the boost function as per page
18 (see install video on
).
http://www.bionizer.com.au/instructions-videos/
o
After the boost function has completed, the Bionizer will switch back to its daily operation in auto mode.
o
Check your copper levels again to make sure the levels are the required level of 0.5-0.6. If levels are still low, activate
boost function again with recent copper level measurement.
o
Enjoy your chlorine free pool!
For the first couple of weeks test your copper level every 3-4 days and after that once a week. Adjust Bionizer settings up
or down as per page 14 if needed, until you have found the right ionizing time/output for your pool. pH level has to be
within the correct range for an accurate copper reading.
PS. Keep your instruction booklet in a safe place, this and your Snap Pool Balance Chart are your guides to a trouble free
pool. Use them!
QR CODE LINK TO INSTRUCTION VIDEOS
If you have a QR Code App on your smartphone or tablet, scan the code below to link directly to the instruction videos.
